Nautilus E616 Service Manual page 42

Using a 6mm hex key and a 13 mm wrench, remove the 2 indicated
4.
bolts from the Lower Handlebar Arms and Pedals. Set the hardware safely
aside for reassembly.
Be aware that the Handlebar Arms will be loose and may
pivot when the hardware is removed. This step may require
two people.
Using a 13 mm wrench, remove the
5.
hardware from the Lower Handlebar Arms and
the Arm Pivot Rod. Remove the hardware, and
Upper and Lower Handlebar Arms. Set them
safely aside for reassembly.
Using a 6mm hex key, loosen and remove the indicated hardware
6.
from the Legs, and set it safely aside for reassembly. On each side of the
machine, remove the Leg and Pedal together from the Rail Assembly and
set them safely aside for reassembly.
NOTICE: This step may require two people.
X2
13 mm
X2
6mm
X2
X2
6mm
42
X2