Nautilus E616 Service Manual page 60

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet
and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure
location.
Note: Your machine may not match the image. Model Year 2014 (MY14) is shown.
For reference only.
Loosen and remove the 4 screws from the Handlebar Shrouds.
1.
Remove the Handlebar Shrouds and set them safely aside.
2. MY14 model only—Loosen and remove the screw (A) that attaches
the Console Junction Cover (C) to the Console. Set the screw safely aside
for reassembly.
3. To get access to the mount plate, carefully loosen and remove the
hardware (B) that attaches the Static Handlebar Assembly to the Mast
using a 6mm hex key. Slide the Console Junction Cover (C) down the
Mast. Reinstall 1 bolt to hold the Static Handlebar Assembly in position on
the Mast. Set the other hardware safely aside for reassembly.
NOTICE:
This step may require two people.
4.
Assembly. Carefully lift the Console off the Mast.
5.
from the back of the Console. Set the Console and screws safely aside for
reassembly.
Note:
require two people.
X4
#2
Console-static handlebar not shown for clarity
D
60
A
B
C
D
B