Nautilus E616 Service Manual page 83

6.
Pulleys.
To remove the hardware (I) from the Flywheel (A), use the 17 mm
7.
open end wrench to hold the nut on one side steady and remove the nut
on the opposite side with the 17 mm socket and wrench. Set the hardware
safely aside.
Adjust the angle of the Tensioner Assembly (C) to allow the Flywheel
8.
(A) to move forward. Remove the Flywheel from the Frame brackets (F)
Note: The Flywheel is heavy. This step may require two people.
9.
10. Hold the Flywheel (A) near the Frame brackets (F) and put the new
position around the Tensioner Assembly (C). Be sure that the upper por-
Note: This step may require two people.
11. Align the Flywheel axle (A2) in the Main Frame brackets (F). Hand
tighten the hardware from step 4 on each end of the Flywheel axle.
12.
Pulley.
13. Before you fully tighten the Flywheel hardware (I), adjust the
Tensioner Assembly (C) to the position marked in step 3 and tighten the
hardware (E, C1, C2). Make sure that the belt tension is correct. Refer to
the "Belt Tension Adjustment" section in this manual.
Note: This step may require two people.
14. To tighten the Flywheel hardware (I), use the 17mm open end wrench
to hold the nut on one side steady and tighten the nut on the opposite side
with the 17mm socket and wrench.
Note: Before fully attaching the Shrouds, power up the machine to
verify that the Magnet Arm (B) can move freely, and that the
Brake Magnet and Flywheel (A) do not touch at the maximum
resistance level.
15. Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
A
H
C3
C2
A1
C1
83
E
A2
I
F
C
G