Nautilus E616 Service Manual page 57

6. Using a 6 mm hex key, remove the remaining bolt (B, from Step 3)
again, and remove the Static Handlebar and Console Junction Cover (C).
NOTICE:
a rubber band or wire tie.
Using a 6mm hex key and a 13 mm wrench, remove the 2 indicated
7.
bolts from the Lower Handlebar Arms and Pedals. Set the hardware safely
aside for reassembly.
Be aware that the Handlebar Arms will be loose and may
pivot when the hardware is removed. This step may require
two people.
Using a 13 mm wrench, remove the hardware from the Lower
8.
Handlebar Arms and the Arm Pivot Rod. Remove the hardware, Upper
and Lower Handlebar Arms, and Arm Pivot
Rod. Set them safely aside for reassembly.
X2
13 mm
X2
6mm
57
C
X2