Ldp Configuration Management Tasks; Disabling Ldp; Modifying Targeted Session Parameters - Nokia 7705 SAR-W Series Manual

MPLS Guide

5.11 LDP Configuration Management Tasks

This section discusses the following LDP configuration management tasks:

5.11.1 Disabling LDP

The no ldp command disables the LDP protocol on the router. All parameters revert
to the default settings. LDP must be shut down before it can be disabled.
Use the following CLI syntax to disable LDP:
CLI Syntax:
Example:

5.11.2 Modifying Targeted Session Parameters

You can modify targeted session parameters without shutting down entities.
However, for any LDP timers (hello or keepalive timers), the changes do not take
effect until a shutdown/no shutdown command is performed on the LDP session.
The no form of a targeted-session parameter command reverts modified values
back to the default.
The following example displays the CLI syntax to revert targeted session parameters
back to the default values.
Example:
3HE 18686 AAAB TQZZA
• Disabling LDP
• Modifying Targeted Session Parameters
• Modifying Interface Parameters
no ldp
shutdown
config>router# ldp
config>router>ldp# shutdown
config>router>ldp# exit
config>router# no ldp
config>router# ldp
config>router>ldp# targeted-session
config>router>ldp>targeted# no disable-targeted-session
config>router>ldp>targeted# no hello
config>router>ldp>targeted# no keepalive
config>router>ldp>targeted# shutdown
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
Label Distribution Protocol
441