Nokia 7705 SAR-W Series Manual page 471

MPLS Guide
5.12.2.1.3
interface-parameters
Syntax interface-parameters
Context config>router>ldp
Description This command enables the context to configure LDP interfaces and parameters that apply to
LDP interfaces.
interface
Syntax interface ip-int-name [dual-stack]
[no] interface ip-int-name
Context config>router>ldp>if-params
Description This command enables LDP on the specified IP interface.
The no form of the command deletes the LDP interface and all configuration information
associated with the LDP interface.
The LDP interface must be disabled using the shutdown command before it can be deleted.
You can configure different parameters for IPv4 and IPv6 LDP interfaces by entering ipv4 or
ipv6 as the next command.
Parameters dual-stack — distinguishes between configurations created prior to 7705 SAR Release
ip-int-name — specifies an existing interface. If the string contains special characters (#,
3HE 18686 AAAB TQZZA
Interface Parameters Commands
9.0 from those created in Release 9.0 or later when the interface node
implementation was changed to include both IPv4 and IPv6 contexts. If the dual-
stack keyword is used, then the IPv4 interface context is not created. If the keyword
is not used, then the IPv4 interface context is automatically created.
When entering an already configured interface, there is no need to provide the
keyword and it will be ignored if it is included.
By default, all configurations created in Release 9.0 or later include dual-stack.
$, spaces, etc.), the entire string must be enclosed within double quotes.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
Label Distribution Protocol
471