Nokia 7705 SAR-W Series Manual page 215

MPLS Guide
3.24.2.1.9
static-lsp
Syntax [no] static-lsp lsp-name
Context config>router>mpls
Description This command configures static LSPs on the ingress router. The static LSP is a manually
configured LSP where the next-hop IP address and the outgoing label (push) must be
specified.
The no form of this command deletes this static LSP and associated information.
The LSP must be shut down before it can be deleted. If the LSP is not shut down, the
no static-lsp lsp-name command generates a warning message on the console indicating
that the LSP is administratively up.
Parameters lsp-name — identifies the LSP. Allowed values are any string up to 32 characters long
push
Syntax push label nexthop ip-address
no push label
Context config>router>mpls>static-lsp
Description This command specifies the label to be pushed onto the label stack and the next-hop IP
address for the static LSP.
The no form of this command removes the association of the label to push for the static LSP.
Parameters label — specifies the label to push on the label stack
3HE 18686 AAAB TQZZA
Static LSP Commands
composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double
quotes.
Label values 16 through 31 are 7705 SAR reserved
Label values 32 through 1023 are available for static assignment
Label values 1024 through 2047 are reserved for future use
Label values 2048 through 18431 are statically assigned for services
Label values 28672 through 131071 are dynamically assigned for both MPLS and
services
Label values 131072 through 1048575 are reserved for future use.
Values 16 to 1048575
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS and RSVP-TE
215