Figure 3 Entropy Label And Load Balancing - Nokia 7705 SAR-W Series Manual

MPLS and RSVP-TE
At the LSR, if hashing is enabled, the LSR recognizes the ELI and uses the entropy
label value as the hash result. If the entropy-label command had been disabled at
the iLER, the LSR would not find the ELI and would default to hashing based on the
label stack, if applicable.
Entropy Label and Load Balancing
Figure 3
Node B
At the ingress LER:
config>service>cpipe>spoke-sdp>entropy-label
config>service>epipe>spoke-sdp>entropy-label
config>service>ipipe>spoke-sdp>entropy-label
config>service>vpls>spoke-sdp>entropy-label
config>service>vpls>mesh-sdp>entropy-label
config>service>vprn>entropy-label
config>service>vprn>interface>spoke-sdp>entropy-label
config>router>isis>segment-routing>entropy-label
config>router>ospf>segment-routing>entropy-label
32
7705 SAR-8 7705 SAR-18
iLER LSR_1
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
7705 SAR-8
eLER CE
3HE 18686 AAAB TQZZA
MPLS Guide
26222