Behavior Of The Lsp Path Update - Nokia 7705 SAR-W Series Manual

Service aggregation router, mpls
Table of Contents

Advertisement

PCEP

4.5.2 Behavior of the LSP Path Update

When the pce-control option is enabled, the PCC delegates control of the RSVP-TE
LSP to the PCE.
The NRC-P sends a path update using the PCUpd message in the following cases:
The procedures for the path update are described in
RSVP-TE LSP, the PCUpd message from the PCE contains the interface IP address
or system IP address in the computed ERO. The PCC signals the path using the
ERO returned by the PCE and, if successful, programs the data path, then sends the
PCRpt message with the resulting RRO and hop labels provided by RSVP-TE
signaling.
If the signaling of the ERO fails, the ingress LER returns a PCErr message to the
PCE with the LSP Error code field of the LSP-ERROR-CODE TLV set to a value of 8
(RSVP signaling error).
If an RSVP-TE LSP has the no adaptive option set, the ingress LER cannot perform
an MBB for the LSP. A PCUpd message received from the PCE is then failed by the
ingress LER, which returns a PCErr message to the PCE with the LSP Error code
field of the LSP-ERROR-CODE TLV set to a value of 8 (RSVP signaling error).
326
• a failure event that impacts a link or a node in the path of a PCE-controlled LSP
The operation is performed by the PCC as a Make-Before-Break (MBB) if the
LSP remained in the up state due to protection provided by FRR or a secondary
path. If the LSP went down, the update brings it into the up state. A PCRpt
message is sent by the PCC for each change to the state of the LSP during this
process. See
Behavior of LSP MBB
• a topology change that impacts a link in the path of a PCE-controlled LSP
This topology change can be a change to the IGP metric, the TE metric, admin-
group, or SRLG membership of an interface. This update is performed as an
MBB by the PCC.
• the user performed a manual resignal of a PCE-controlled RSVP-TE LSP path
from the NRC-P
This update is performed as an MBB by the PCC.
• the user performed a Global Concurrent Optimization (GCO) on a set of PCE-
controlled RSVP-TE LSPs from the NRC-P
This update is performed as an MBB by the PCC.
Use subject to Terms available at: www.nokia.com
for more information.
© 2022 Nokia.
MPLS Guide
LSP
Initiation. However, for an
3HE 18686 AAAB TQZZA

Advertisement

Table of Contents
loading

Table of Contents