Table of Contents
Advertisement
MPLS and RSVP-TE
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
config>router>mpls>lsp-template
Description
This lsp form of this command disables the existing LSP, including the primary and any
standby secondary paths.
The primary and secondary forms of this command administratively disable an LSP path
and disable an existing LSP. Shutting down an LSP path does not change other configuration
parameters for the LSP path.
To shut down only the primary path, enter the config>router>mpls>lsp lsp-name>
primary path-name> shutdown command.
To shut down a specific standby secondary path, enter the config>router>mpls>lsp
lsp-name> secondary path-name>shutdown command. The existing configuration of the
LSP is preserved.
The lsp-template form of this command disables the existing LSP template.
Use the no form of this command to restart the LSP or LSP template. LSPs and LSP
templates are created in a shutdown state. Use this command to administratively bring up the
LSP or LSP template.
Default
lsp — shutdown
primary — no shutdown
secondary — no shutdown
lsp-template — shutdown
to
Syntax
to ip-address
Context
config>router>mpls>lsp
Description
This command specifies the IP address of the egress router for the LSP. This command is
mandatory to create an LSP.
An IP address for which a route does not exist is allowed in the configuration. If the LSP
signaling fails because the destination is not reachable, an error is logged and the LSP
operational status is set to down.
If the to address does not match the SDP address, the LSP is not included in the SDP
definition.
Default
n/a
Parameters
ip-address — specifies the IP address of the egress router
204
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
MPLS Guide
3HE 18686 AAAB TQZZA
Advertisement
Table of Contents
