Nokia 7705 SAR-W Series Manual page 299

MPLS Guide
rsvp
Syntax [no] rsvp [lsp lsp-name] [sender sender-address] [endpoint endpoint-address] [tunnel-id
no rsvp
Context debug>router
Description This command enables and configures debugging for RSVP.
Parameters lsp-name — name that identifies the LSP. The LSP name can be up to 80 characters long
sender-address — specifies the system IP address of the sender (a.b.c.d)
endpoint-address — specifies the far-end system IP address (a.b.c.d)
tunnel-id — specifies the RSVP-TE tunnel ID
lsp-id — specifies the LSP ID
ip-int-name — identifies the interface. The interface name cannot be in the form of an IP
auth
Syntax auth
no auth
Context debug>router>rsvp>event
Description This command debugs authentication events.
The no form of the command disables the debugging.
Parameters detail — displays detailed information about authentication events
nbr
Syntax nbr [detail]
no nbr
Context debug>router>rsvp>event
Description This command debugs neighbor events.
3HE 18686 AAAB TQZZA
tunnel-id] [lsp-id lsp-id] [interface ip-int-name]
and must be unique.
Values 0 to 4294967295
Values 1 to 65535
address. Allowed values are any string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS and RSVP-TE
299