Common Configuration Tasks; Configuring Mpls Components - Nokia 7705 SAR-W Series Manual

Service aggregation router, mpls

Table of Contents

3.20 Common Configuration Tasks

This section provides a brief overview of the tasks to configure MPLS and provides

the CLI commands.

The following protocols must be enabled on each participating router:

In order for MPLS to run, you must configure at least one MPLS interface in the

config>router>mpls context.

Use the MPLS and RSVP-TE CLI syntax shown in the following information for:

3HE 18686 AAAB TQZZA

• RSVP-TE (for RSVP-TE-signaled MPLS only)

• An interface must be created in the config>router>interface context before it

can be applied to MPLS.

• In the config>router>mpls context, configure the path parameters. A path

specifies some or all hops from ingress to egress. A path can be used by multiple

• When an LSP is created, the egress router must be specified in the to command

and at least one primary or secondary path must be specified. All other settings

under the LSP hierarchy are optional.

Configuring Global MPLS Parameters

Configuring an MPLS Interface

Configuring MPLS Paths

Configuring an MPLS LSP

Configuring a Static LSP

Configuring Manual Bypass Tunnels

Configuring RSVP-TE Parameters and Interfaces

Configuring RSVP-TE Message Pacing Parameters

Use subject to Terms available at: www.nokia.com

MPLS and RSVP-TE