Microphone; Packet Equipment - Kenwood TM-733A Instruction Manual

One External Speaker
TM-733A Speaker jack 1
/ (General)
External speaker
Two External Speakers
2
TM-733A External
/ (General) speaker 2
\ " External
I. speaker 1
Speaker jack 2 Speaker jack 1
MICROPHONE
To communicate in the voice modes, plug a 600 Q
microphone equipped with an 8-pin modular connector
into the modular socket on the Front Panel of the
transceiver. Press firmly on the plug until the locking
tab clicks..
10
PACKET EQUIPMENT
If you intend to use this transceiver for Packet
operation, you will need the following equipment:
+ Personal computer with communications software
(Alternatively, a "dumb" terminal capable of sending
ASCII commands)
+ TNC (Terminal Node Controller)
+ TNC power supply
+ RS-232C cable
* 6-pin mini DIN plug (optional PG-5A)
Refer to the accompanying diagram and the associated
instruction manuals to configure the equipment as
shown. Connect your TNC to the DATA connector on
the transceiver Front Panel using a cable equipped with
a 6-pin mini DIN plug. Do not share a single power
supply between the transceiver and the TNC. Keep as
wide a separation between the transceiver and
computer as practical to reduce noise-pickup by the
transceiver.