Kenwood TM-733A Instruction Manual page 55

INITIALIZING MEMORY
If your transceiver seems to be malfunctioning,
initializing the transceiver may resolve the problem.
There are several methods of initializing or resetting the
transceiver.
+ Partial Reset - Single Band
+ Partial Reset - Both Bands
* Full Reset excluding Programmable Memory
+ Full Reset including Programmable Memory
Note: See "RESETTING PROGRAMMABLE MEMORY" {page 56}
if you want to initialize the Programmable Memory only.
m@ Partial Reset - Single Band
This reset initializes settings on a single band only.
Press [VFO]+[BAND SEL]+ POWER ON.
* Only the band corresponding to the [BAND SEL]
pressed resets to default settings. Functions that
cannot be set independently for each band are
not reset. The following drawing illustrates the
144 MHz band being reset.
The following items are not reset:
+ Microphone PF keys
* Beep function
+ Automatic Band Change (A.B.C.)
« Lock
+ Mute
* Time-out Timer (TOT)
+ Automatic Page Cancel
+ Display Demonstration mode
+ Display Dimmer
+ Transmit band
* Control band
+ Repeater Delay time for DTSS and Page
operation
Note: After the reset, the RD output remains connected to the band
used last. If the RD output is not connected to the band you want,
press [BAND SEL] for that band.
m Partial Reset - Both Bands
This reset initializes all settings on both bands
except the memory channels, the Call channels, the
Page code channels, and the Programmable
Memory channels.
Press [VFO]+ POWER ON.
+ Hold [VFO] until a beep is heard after the power
is switched ON.
49