Kenwood TM-733A Instruction Manual page 51

ERASING MEMORY CHANNELS
Although it is possible to overwrite existing data in any
of the memory channels with new data, at times you
may wish to clear data from memory channels without
entering new data. It's convenient to clear channels no
longer used so you can identify channels that are free
for memorizing new frequencies. Memory channels
that contain no data cannot be recalled while in Memory
Recall.
1 Press [BAND SEL] to select your desired band.
2 Press [MR] to select Memory Recall.
3 Select the desired memory channel by turning the
Tuning control or pressing microphone [UP]/[DWN].
4 Press [F]+[MR].
+ The contents of the memory channel are erased.
Note: Memory channel 1 cannot be erased.
CALL CHANNEL
The Call channel can be used to store any frequency
that can be selected on your transceiver that you wish
to make your main operating frequency. The Call
channel can be programmed with a simplex frequency
or a split frequency. No matter what mode the
transceiver is in, the Call channel always can be
selected quickly. You may wish to dedicate the Call
channel on a group-wide basis as an emergency
channel only to be used for urgent communications. In
this case, one of the Call channel scans {page 71} will
be useful.
mw Recalling the Cail Channel
1 Press [BAND SEL] to select your desired band.
2 Press [CALL] to retrieve the contents of the Call
channel on the selected band.
+ "C" appears on the Display.
° r
{unc *
7 TY es
SHIFT TONE CALL LOW
+ If [CALL] is pressed again, "C" clears and the
previous mode is restored.
+ The Tuning control and microphone
(UP]/[DWN] do not function while the Call
channel is selected.
45