Kenwood TM-733A Instruction Manual page 77

3 Press [VFO] (1), and Scan starts at the
frequency currently displayed.
* The decimal starts blinking to indicate
scanning is in progress.
* The scan direction is the same as last used.
If the Tuning control is turned, or microphone
[UP] or [DWN] is pressed after using Scan,
the scan direction may be different next time
Scan is used.
* The default direction is upward in frequency.
4 To reverse the scan direction, turn the Tuning
control, or press microphone [UP]/[DWN].
+ Upward scan:
Turn Tuning control clockwise, or
Press microphone [UP].
+ Downward scan:
Turn Tuning counterclockwise, or
Press microphone [DWN]
5 To cancel Programmable Band Scan, press
[BAND SEL] for the band being scanned or
[PTT].
Note: Squelch must be closed for Scan to function {page 27}.
MHz SCAN
MHz Scan allows you to scan a 1 MHz segment of the
band. The current 1 MHz digit determines the limits of
the scan. For example, if the current frequency is
438.400 MHz, then MHz Scan would scan from
438.000 MHz to 438.975 MHz. The exact upper limit
depends on the step size selected.
While using either Band Scan {page 69} or
Programmable Band Scan {page 70}, press [MHz] to
start or stop MHz Scan.
« Stopping MHz Scan while the current frequency is
equal to or between the limits of Programmable
Band Scan causes Programmable Band Scan to
resume. Otherwise, Band Scan resumes.
CALL/VFO SCAN
Use Call/VFO scan to monitor both the Call channel
and the current VFO frequency on the selected band.
1 Press [BAND SEL] to select your desired band.
2 Press [VFO] to select VFO mode.
3 Press [CALL] (1 s).
4
To cancel Call/VFO Scan, press [BAND SEL] for
the band being scanned or [PTT].
71