Preparation For Dtss Operation; Dtss Code Selection - Kenwood TM-732A Instruction Manual
Hide thumbs
Also See for TM-732A:
- Service manual (82 pages) ,
- User manual (80 pages) ,
- Instruction manual (79 pages)
Table of Contents
Advertisement
2. DTSS (Dual Tone Squelch System)
2-1. Preparation for DTSS Operation
This function allows the squelch to be turned on in
the receive mode on reception of a three-digit code
matching the DTSS code selected in your radio.
Once the squelch is turned on by reception of a
matching code, it operates normally from then on. If
no signal is received for longer than 2 seconds, the
squelch is turned off until a matching code is
received.
enn
NOTE
This function is not available in some areas.
The DTSS (or PAGING) code may not be accepted if
the repeater is "identifying". If this should occur you
should press the PTT switch again, and retransmit
the DTSS (or PAGING) cord.
There are two recommended methords of
compensating for this situation.
1. Press the PTT switch for a few seconds, send the
DTSS (or PAGING) cord, release the PTT switch,
then press the PTT switch again and resend the
appropriate cord.
2. Proper DTSS (or PAGING) operation will occur if
you ensure the battery saver circuit is disabled
whenever you intend to operate using eithr the
DTSS or PAGING modes.
2-2. DISS Code
DTSS codes from 000 through 999 can be selected
from the VFO mode and stored in memory
channels
and the CALL channel.
The initial DTSS Code selection is O00.
2-3. DTSS Code Selection
Change the DTSS code using the same procedure.
1. Press the BAND SEL key to select the desired band.
2. Press the F key. The F indicator lights.
3. Press the SHIFT/DTSS key while the F indicator is
on (10 seconds).
This will cause the display to shift as shown is the
diagram below. Continue pressing the SHIFT/DTSS
key until the DT indicator appears in the display.
ee
er
Ot
YON SUES TIAM
ian ON.
a Ment
DTSS
:ON
» PAGING :ON
if
all
channe
:
:
FP!
py:
,
x
operation
er
parr ing
2a
4. Press the F key for longer than 1 second and then
press the SHIFT/DTSS key. The display will change
to the DTSS code entry mode. (See example below.)
The digit just to the left of the "0" will be flashing.
61
Advertisement
Table of Contents
