Kenwood TM-733A Instruction Manual page 105

TONE ALERT
Tone Alert provides an audible alarm to indicate when
someone is transmitting on the frequency you are
monitoring.
Tone Alert is an effective partner with CTCSS, Page, or
DTSS. When the correct signaling comes through, your
transceiver beeps to alert you of an incoming call from
a specific station.
ACTIVATING TONE ALERT
1 Press [BAND SEL] to select your desired band, and
select the prearranged frequency.
2 Activate CTCSS, Page, or DTSS if you want to use
these together with Tone Alert.
3 Press [F], [T.ALT].
+ Abell" appears. Each time this key combination
is pressed, Tone Alert toggles ON and OFF.
«If Tone Alert is ON, there is no speaker output
except the alarm tone when a signal is received.
To hear receive audio, assign the Monitor
function {page 83} to microphone [PF] before
switching on Tone Alert.
lawrence
Mul
CALL LOW SHIFT TONE
4 When the correct signal is received, the transceiver
rings 3 times, the "bell" begins blinking, and the Call
Number increments.
+ The Display shows the number of minutes and
seconds elapsed after the last signal was
received. After 59 minutes 59 seconds pass, the
Display changes to 01.00 and continues
counting. After 59 hours 59 minutes pass,
counting stops. When the next signal is received,
the time resets to 00.00 and counting continues.
Each time a new signal is received, the time
resets to 00.00.
+ The Call Number records the number of calls
received to a maximum of 99.
+ The alarm tone can be changed if you prefer
{page 100}.
5 Exit Tone Alert by pressing [MHz] or [PTT].
99