Kenwood TM-733A Instruction Manual page 89

* The following Front Panel functions or types of
functions cannot be assigned to a PF key:
[F]
[PWR]
Tuning control
[PTT]
[F] (1s)
[KEY]+ POWER ON
* The Front Panel key will still function normally
after "copying" its function to a PF key.
* To restore the default functions shown in the
chart on page 82, do a Full Reset {page 50}.
m@ Monitor Function
Monitor allows you to override any squelch systems
being used so activity on a frequency can be heard.
This is handy to quickly listen to a frequency without
actually changing the squelch setting or disabling
the squelch system.
Press [F]+ POWER ON to assign the Monitor
function to microphone [PF].
+ Reconfigure [PF] {page 82} to cancel this
function.
To use the Monitor function, press microphone [PF]
to toggle the function ON or OFF. Scan will not
function if Monitor is ON (squelch open).
g@ Enter Function
The Enter function is used for entering digits from an
MC-45DM microphone.
Press [F]+[VFO]+ POWER ON to assign the Enter
function to microphone [PF].
+ Refer to Keypad Direct Entry.
REMOTE FUNCTIONS USING TH-7
The transceiver can be controlled with the TH-7
(General market transceiver) simply by connecting the
cable supplied with the TH-7 between the transceivers.
The TH-7 is also useful as a speaker-microphone for
the transceiver. See the TH-7 instruction manual for
details. The Remote Control status {page 80} does not
affect operation of the TH-7.
When using a TH-7 for Remote Control of this
transceiver, switch ON the RD output function
{page 29}.
Also, the DTMF dialer cannot be used from a TH-7.
KEYPAD DIRECT ENTRY
The Enter function allows you to enter frequency digits,
memory channel digits, or Tone number digits directly
from the MC-45DM microphone. While using Remote
Control, pressing the [A] key also places the
transceiver into direct entry mode.
83