Rd Output Squelch Control; Band Select - Kenwood TM-733A Instruction Manual

3 Press [MHz] or microphone [PTT] to return to the
previous mode.
+ Any Front Panel button, microphone button, or
switch can be used in this step except
microphone [UP]/[DWN] and the microphone
DTMF keypad keys. It's not advisable to use
[BAND SEL], [CONT SEL], or [PWR]
because they will also perform their own
functions.
mw RD Output Squelch Control
When this function is switched ON, receive audio is
available at the RD terminal in the microphone
connector only when the squelch is open. This
function is necessary if you want to connect a TNC
for Packet operation to the microphone connector
instead of using the DATA connector. However, the
DATA connector is recommended for this application
{page 10}.
Press [TONE]+ POWER ON to toggle the RD output
squelch control ON or OFF.
+ "ON" appears briefly on the lower right corner of
the Display when the function is switched ON.
The default is ON.
BAND SELECT
This transceiver can be used in one of the following
configurations at a time. Configuration 1 is the default.
Receive Transmit
VHF and UHF VHF or UHF
VHF and VHF VHF
UHF and UHF UHF
Configuration
In Configuration 1, you can switch the Transmit band
between VHF and UHF by using the [BAND SEL]
buttons. Press the left [BAND SEL] button to select the
144 MHz band as the Transmit band and the right
[BAND SEL] button to select the UHF band as the
Transmit band. You always know which is the Transmit
band by checking the "PTT" indicator on the Display.
The "PTT" indicator appears above the frequency that
is the current transmit frequency.
Press the [CONT SEL] button to toggle the Control
band between the 144 MHz band and the 430/440 MHz
band. The left Control Select indicator lights while the
144 MHz band is the Control band and the right Control
Select indicator lights while the 430/440 MHz band is
the Control band.
29