Preparation For Dtss Operation; Dtss Code Selection - Kenwood TM-732A Instruction Manual

2. DTSS(Oual Tone Squelch System)
2-1. Preparation for DTSS Operation
This function allows the squelch to be turned on in 2-3. DTSS Code Selection
the receive mode on reception of a three-digit code
matching the DTSS code selected in your radio.
Change the DTSS code using the same procedure.
Once the squelch is turned on by reception of a ;
: : 1. Press the BAND SEL key to select the desired band.
matching code, it operates normally from then on. If rv '
eg eNO id eee 2. Press the F key. The F indicator lights.
no signal is received for longer than 2 seconds, the " ae é
squelch is turned off until a matching code is 3. Press the SHIFT/DTSS key while the F indicator is
NOTE This will cause the display to shift as shown is the
This function is not available in some areas. diagram below. Continue pressing the SHIFT/DTSS
The DTSS (or PAGING) code may not be accepted if | key until the DT indicator appears in the display.
the repeater is "identifying". If this should occur you
should press the PTT switch again, and retransmit eas eh mala te 254s 25 9 Soe mana
the DTSS (or PAGING) cord. ~ feceesseeeeeeeseeeeeeeees
There are two soars eer teed methords of bi Memon ie DTSS :ON | PAGING :ON
compensating for this situation. all:channe display:ON | | P(*)display :ON
1. Press the PTT switch for a few seconds, send the Operation eee ! id pce
DTSS (or PAGING) cord, release the PTT switch, (*): AO~5
then press the PTT switch again and resend the
appropriate cord. 4. Press the F key for longer than 1 second and then
2. Proper DTSS (or PAGING) operation will occur if press the SHIFT/DTSS key. The display will change
you ensure the battery saver circuit is disabled to the DTSS code entry mode. (See example below.)
BASE oe ec Se opeareuangeN ete The digit just to the left of the "0" will be flashing,
2-2. DTSS Code
The initial DTSS Code selection is 000.
=r 000
wOO00
61