Replacing Fuses; Antenna Connection - Kenwood TM-733A Instruction Manual

Note:
For your transceiver to fully exhibit its performance capabilities,
the following optional power supply is recommended:
PS-33 (20.5 A, 25% duty cycle).
¢ Before connecting the DC power supply to the transceiver, be
sure to switch the transceiver and the DC power supply off.
¢@ Donot plug the DC power supply into an AC outlet until you make
all connections.
m@ Replacing Fuses
If the fuse blows, determine the cause then correct
the problem. After the problem is resolved, only
then replace the fuse. If newly installed fuses
continue to blow, disconnect the power plug and
contact your dealer or the nearest Service Center for
assistance.
Fuse Location
TM-733
Fuse Current Rating
Supplied Accessory
Cable
CAUTION: Only use fuses of the specified type and rating.
ANTENNA CONNECTION
The type of the antenna system, consisting of the
antenna, ground, and feed line, will greatly affect the
successful performance of the transceiver.
Use a
properly adjusted 50 Q antenna of good quality
designed for operation at your operating frequency to
let your transceiver perform at its best.
CAUTION: