Kenwood TM-733A Instruction Manual page 42

4 Turn the Tuning control, or press microphone
[UP]/[DWN], to select the desired step size.
+ The available steps are as follows:
5 kHz «——> 10 kHz +—+15 kHz
25 kHz <—>12.5 kHz «—»20 kHz
+ When using the UHF/ UHF configuration
{page 30}, the frequency steps of 5 kHz and
15 kHz are not available on the U2 band.
5 Press [MHz] or microphone [PTT] to return to the
VFO mode.
Any Front Panel button, microphone button, or
switch can be used in this step except
microphone [UP]/[DWN] and the microphone
DTMF keypad keys. It's not advisable to use
[BAND SEL], [CONT SEL], or [PWR]
because they will also perform their own
functions.
m@ 1 MHz/ 10 MHz Functions
The 1 MHz and 10 MHz functions allow rapid
frequency excursions up or down the band with a
minimum of control turning or button pushing.
These functions temporarily provide either a 1 MHz
ora 10 MHz step size.
1 Press [BAND SEL] to select your desired band.
2 Press [VFO] to select VFO mode.
3 Press [MHz] to select the 1 MHz function, or
Press [F]+[MHz] to select the 10 MHz function.
* 1 MHz function:
All digits blank except the 100 MHz, 10 MHz,
and 1 MHz digits.
'i oy
! "oa
Y AGS:
CALL LOW SHIFT TONE
* 10 MHz function:
All digits blank except the 100 MHz and
10 MHz digits.
[ow
hry
CALL SHIFT LOW TONE