Kenwood TM-733A Instruction Manual page 91

= Memory Channel or
Tone/CTCSS Number Entry
(kHz) This is similar to Frequency Entry except this
function is used when Memory Recall or Tone Select
is being used. If you want to choose a memory
channel or Tone number quickly without scrolling
through many other choices, this is the method to
use.
1 Press [BAND SEL] to select your desired band.
2 Press [F]+[VFO]+ POWER ON, or if you prefer to
use Remote Control, press [F]+[CONT SEL]
instead.
Note:
@ Ifany key other than [0] to [9] or [PF] ([A] if using Remote 3 Press [MR] to select Memory Recall, or
Control) is pressed, or if the next entry is not made within 10
[F] (1s), [T.SEL] to select Tone Select.
seconds, the previous frequency will be restored.
If [PF] ({A] if using Remote Control) is pressed while entering the 4 Press microphone [PF] or if using Remote
frequency, the new data is accepted for the digits entered and the Control, press microphone [A] instead.
Bievious data remains unchanged fee the aoe not yet entered.
. "appears.
The transceiver is ready to
@
Turning the Tuning control, or pressing microphone [UP]/[DWN],
receive digits from the microphone.
while entering the frequency cancels the new numeric data
entered, and raises or lowers the previously displayed frequency.
85