Kenwood TM-733A Instruction Manual page 102

Receiving a Call with a Group Code
When a signal is received encoded with the correct
Group code, the squelch opens and you hear an
alert tone from the speaker. In addition, the
received Group code and the Page memory (1 to 5)
in which that Group code has been stored appear.
\
ps
ooo =
Pay
CALL LOW SHIFT TONE
Press [PTT] while "P" is blinking to respond to the
calling party.
Note:
5
a4
"Err" appears on the display if your transceiver fails to receive the
Page code correctly.
Each time [PTT] is pressed, the microphone is inhibited, and the
Page code is transmitted. After establishing a contact, you can
eliminate this pause by switching the Page function OFF.
Page may not function in the following situations:
+ Page is switched ON for both the VHF and UHF bands
+ The other station is using a battery saver function.
+ A repeater ID and the Page code are received
simultaneously.
If difficulty is experienced in these cases, release [PTT], then
press [PTT] again.
If Page and Tone Alert are ON, there is no speaker output except
the alarm tone even if a signal is received with the correct Page
code.
96