Rit Control; Хіт Control; Af Function - Kenwood TS-450S Instruction Manual

4-11-12. ВІТ Control
RIT indicator
4-11-13. ХІТ Control
ХІТ indicator
4-11-14. AF Function
The RIT control allows shifting the receiver frequency
+1.1 kHz. Use of the RIT control will not affect the
transmit frequency.The RIT step size is either 10 Hz or
20 Hz. (Please refer to Section 4-11-15.)
When the RIT is ON, the RIT indicator will light, and the
receive frequency can be adjusted by using the ΗΙΤ/ΧΙΤ
control.
When the RIT is ON the transmit frequency may be
different from the receive frequency. For normal
operation leave the RIT OFF. It should be used only
when necessary.
(Please refer to Section 4-11-15.)
Offsets of +11 kHz are possible.
When RIT/XIT are off, the display is off.
transmit frequencies rather than the TX frequency.
1. Press the A=B key during simplex transmission to
make the VFO A and VFO B frequencies equal.
2. Press the SPLIT key.
3. Press and Hold the TF-SET key then press numeric
key 7(AF).
Keep the TF-SET key depressed.
The display shows dF 00.00 kHz.
4. Select the desired split frequency using the VFO
tuning knob or the M.CH/VFO CH control.
If the TF-SET key is released, the receive frequency
is displayed.
If the key is pressed again, the frequency set in step4
is displayed.
5. Press the microphone PTT switch, or set the
REC/SEND switch to SEND.
To return to the original TF-SET key function, press and
hold the TF SET key then press numeric key 7 again.
The transmit frequency set with the AF function remains
in the transmit VFO even after the function has been
canceled.
51