Symbols Used To Indicate Operation Keys - Mitsubishi MELSEC F FX-40DU-E Handy Manual

1.
INTRODUCTION
Page
Layout in this Manual
1.5.3
Symbols used to indicate operation keys
(1)
The symbol used to indicate an FX-40DU-E operation key in the text of this manual is
[ I
and a
rectangular box is used in diagrams.
Examples: Text; [ 0 I , [CLEAR], [ENTER]
Diagrams;
v l
2
When the cursor keys [ A ] and [
r
] are to be used, the symbol [
r
, A ] may be used
(3) The following symbol is used when the same key is to be pressed a number of times in succession.
m
(4)
Continuous input from one of the cursor keys is achieved by holding the key down for longer than
one second.
( 5 ) When inputting numerical values, the symbol [
0
to
9
] for example, is used to indicate that any
number from
0
through
9
inclusive may be input.
( 6 )
The [SET/
-
] key is indicated in the text of this manual when it has to be used to specify device
numbers, change word devices, etc. When a function is to be set this is indicated in the text by
the symbol [SET] and when a negative numerical value is to be input this is indicated in the text
by a minus symbol 1-1.
(7)
Where a numerical value is to be input on a screen, this is indicated by underlining. Where a
written prompt is to be selected, the currently displayed prompt is highlighted.
Example:
Monitor mode screen
Sampling mode screen
CURRENT
[1234]
SETTING
120001
r
Numerical input
c
SET CONDITION >
1
, This indicates that the
written prompt can be
changed by using the
SAMPLE COND
[ r , A ] k e y s .