Mitsubishi MELSEC F FX-40DU-E Handy Manual page 102

7.
EDIT MODE
Described here is the procedure for modifying a BOX object. After selecting the BOX object to
be modified, select MODIFY OBJECT; the screen shown below will be displayed.
Example BOX modification screen
POS. 1
X:
0 Y :
p
BASIC OPERATION
0109 ENTER 0 to 9 ENTER
POS. 1 m g
(a)
P O S . 2
setting
(b)
ENTER
Return to
Press [CLEAR] to discontinue the
POS.1 setting procedure.
Where no modification is required,
A ENTER
complete
press the [ENTER] key to move
the cursor.
OK
Set the coordinates for the starting point (POS.l) and end point (POS.2) of the box. Coordinates
can be set within the following ranges, taking the top left corner of the screen as the reference
point; (x,y) = (0,O).
The box drawn is delimited
by
POS.1
and
POS.2.
Reference point Example;
for
POS.l
and
POS.l
(x.y)
=
(40,40)
..............................
POS.2:
(x.y)
POS.2
(x.y)
=
(55.70)
POS. 1
i
POS.2
coordinates j coordinates POS.1 coordinates
r
. . . . . . . . . . . . . . . . . . . . . . . . . . . . ;
(a) POS.l x-axis:
o
to 239
y-axis: 0 to 127
coordinates
(b) ~ 0 s . 2 x-axis: 0 to 239
y-axis: 0 to 127
I
Boxes that project off
the screen cannot be
displayed.
(c) Registration
When all settings are completed the message SE-TnNG? will be displayed. If the setting is correct,
press the [ENTER] key at OK to register it.
However, if the error message "SE-TnNG IS INCORRECT" is displayed, clear the error message by
pressing the [CLEAR] key and then check for a mistake in the POS.l and POS.2 settings.