Mitsubishi MELSEC F FX-40DU-E Handy Manual page 14

2.
INSTALLATION, WIRING AND GENERAL SPECIFICATIONS
This unit is installed by setting it into a control panel in the manner described below.
(1)
Cut a hole with the dimensions indicated below into the face of the control panel in which the unit
is to be installed
Note: The panel in which the unit is installed should
have a thickness of no greater than 5mm.
(2)
Insert the FX-40DU-E squarely into the panel.
(3) lnsert the hooks of the brackets supplied as accessories into the hook holes at the top and bottom,
or sides, of the FX-40DU-E and tighten the bolts (included in the package) until the unit is secured.
-
Brackets
(when fitted at left
and right)
5rnm
rnax. Brackets
(when fitted at top and bottom)
Bolt
The tightening torque of the
bolts should be 3 to 5 kg.cm.
The same instructions apply
if the brackets are fitted at
the sides.
"1
Ensure that there is no oostruction within 11 0 mm of
tne 'nstallal'on face before installmg the FX-40DU-E.