Lamp(Ext) - Mitsubishi MELSEC F FX-40DU-E Handy Manual

5.
MONITOR MODE
In the MONITOR MODE the FX-40DU-E can monitor the ONIOFF status of the bit devices in the
programmable controller, the settings and current values of timers and counters, and the contents of
data registers.
In addition, the operator can change the settings and current values of timers and counters and the
contents of data registers in this mode.
The FX-40DU-E also features a dynamic monitor mode in which active states can be monitored
automatically if step ladder instructions are used.
MONITOR MODE SCREEN
Select MONITOR on the mode menu selection
BASIC OPERATION
Mode menu selection
screen is displayed
PrenlhelCLEAR]
iiWWhile
inandhe, .ode
,
.[WM"MODE]
screen displayed
Selmlhe (thewieenm heleft)
ENTER
k E c 9
SelgltheMONlTOR MODE
The functions displayed on the MONITOR MODE screen correspond to the operation keys of the
FX-40DU-E.
[DEV] corresponds to key [ 0 ]
When the [ 0 ] key is pressed the device specification
is displayed.
[DEV] is used to specify device numbers of devices use
current values, and forced ONIOFF.
Ir monitoring, changing settings and
[CMNT] corresponds to key [
1
] (if the [
1
] key is pressed this key functions changes to [NAME]).
[CMNT] and [NAME] select whether displayed devices are displayed using their device codes (X,
Y, M, S, T, C, D, 2, V), or the comments ascribed to them using the screen creation software.
Example:
Code
. J
Comment Note: When [CMNT] is displayed on the FX-40DU-E
display display screen, press key [ 1 ] to display the comment.
X O
Prox sw 1
When [NAME] is displayed, press key [ 1 ] to display
Y 0 lamp
the device code.
[ON] corresponds to key [ 2 ]
[OFF] corresponds to key [
3
]
[STAT] corresponds to key [ 4
Forces a device which is currently displayed and OFF, to come ON.
Forces a device which is currently displayed and ON, to go OFF.
] Used to dynamically monitor states. To perform dynamic monitor-
ing, M8047 must be switched ON in the programmable controller
program.