Mitsubishi MELSEC F FX-40DU-E Handy Manual page 98

7. EDIT MODE
Editing Objects for lndiyidual Screen Settings
( 5 )
LAMP
Described here is the procedure for modifying a LAMP object. After selecting the LAMP object
to be modified, select MODIFY OBJECT; the screen shown below will be displayed.
ExamDle L A M P modification screen
POS. X : 0 Y :
DEV. : M 0
ACTIVE : WHEN ON
0 to 9 ENTER Oto9 ENTER
P O S .
Setlin~
l a 1
0 to 9 ENTER 0109 ENTER
Sl Z E
selling (bi
0
ENTER V, A ENTER Return to
POS.
setting.
O N selling jc) ACTIVE selling [d) CANCEL
(el
A ENTER
ComPMi
Press [CLEAR] to discontinue the procedure.
OK
Where no modification is required, press the
[ENTER]
key
to move the
cursor.
The range of possible settings for each item is described below.
(a) POS. (display position)
The start position for displaying the LAMP is set by specifying coordinates. The top left corner
of the screen is taken as the X,Y reference point (0,O).
...
x-axis setting: A multiple of
8
with 0 as the reference,
s
224
If a number which is not a multiple of 8 is set, it is automatically corrected by discarding
the remainder. Example: X:202
-
X:200
y-axis setting: 0 to 112
(b) SlZE
Set the size of the object with the coordinates specified i n (1) above as the reference point.
Display position
Size: x-axis reference point, (XJ) position
=
(4030)
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
(X.Y)
=
(0.0)
Display position rpPze:
coordinates y-axis
L
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
positian (&y)
=
(40,40)
30
x-axis setting: 15
+
(multiple of 8)
5
239
....
Corrections are made in the
same way as for POS. settings
y-axis setting: 15 to
127
Note that objects projecting outside the screen area cannot be displayed