4.8.6
Connecting Tip to Horn
1. Clean the mating surfaces of the horn and tip. Remove foreign matter from the threaded stud
and hole.
2. Hand assemble the tip to the horn. Assemble dry. Do not use any silicone grease.
3. Use the spanner wrench and an open-end wrench (refer to
Line Cord Color
Torque
Specifications.
Figure 4.22 Connecting Tip to Horn
CAUTION
Table 4.17 Tip to Horn Torque Specifications
Tip Thread
1/4 - 28
3/8 - 24
72
Code) and tighten to the Torque tip specifications in
The horn of 2000x 15 kHz actuator is not to exceed 30 kg for an
ordinary application. If you have an application requiring a bigger
horn, please contact BRANSON.
Torque
110 in.-lbs, 12.42 Nm.
180 in.-lbs, 20.33 Nm.
Figure 4.18 International Harmonized
Table 4.17 Tip to Horn
1019571 REV. 03