Figure 4.12 Rear View Of Actuator, Showing Mounting Surface, Bolt And Guide Pin Locations - Emerson Branson 2000X ae Operating Manual

Figure 4.12 Rear view of Actuator, showing Mounting Surface, Bolt and Guide Pin locations

Rear view of ae/aed actuator is
shown. Although other actuators
will vary in height, referenced
dimensions will be the same for all
models.


54






**These three mounting surfaces are
AIR INLET
CAUTION
 14* ."9
flat within 0.004 in. (0.1mm) TIR, in a
tolerance zone of 16 x 3.5 in. (410 x
,03257$17
AIR SUPPLY MUST BE FREE OF OIL AND WATER
MAX. PRESSURE 100 PSI/690 kPa/6.89 bar
90 mm).
The surface to which the actuator is
mounted must also have the same
flatness tolerance.
. 9  5)%4
GROUND UNIT
BEFORE OPERATING
 .. %&&1
DISCONNECT
AIR AND POWER
BEFORE SERVICING
 1-$4
FOR MOUNTING OF
ACTUATOR USE
M10 X 1.5 FASTENERS
DO NOT ALLOW BOLT
TO PENETRATE
ACTUATOR MORE
THAN 10MM (.4")
 

%08&- 1*/


1019571 REV. 03