Table of Contents
Advertisement
In the event the system isto be installed in a high dust environment, the use of a fan filter
kit (101-063-614) is required.
See
Figure 4.5 Power Supply Dimensional Drawing
Series Power Supply.
Figure 4.14 Connections on Rear of Power Supply
User I/O Connector
Ethernet Connector (Optional)
USER I/O
J3
SW1
ACTU ATOR
SIGNALS
J7
HOST
PRINTER
TERM
J9
J8
Parallel Printer Connector
The cable lengths are limited based on the operating frequency of the welding system.
Performance and results can suffer if the RF cable is crushed, pinched, damaged or
modified. Contact your Branson Representative if you have special cable requirements. In
some cases, remote operation from a User I/O or a Host Computer can be used to solve a
distance limitation.
4.5.5
Input Power (Main)
The system requires single-phase input power, which you connect to the Power Supply
using the integral power cord.
receptacle requirements for your specific power level.
Refer to the unit's Model Data Tag to be sure of the power rating of the Model in your
system.
4.5.6
Output Power (RF Cable)
Ultrasonic Energy is delivered to a screw-on MS receptacle connection on the rear of the
Power Supply, which is connected to the Actuator or the Converter (depending on your
application).
WARNING
56
DIP Switch for User I/O
WARNING
THIS EQUIPMENT COMPLIES WITH
F.C.C. REGUL
ATIONS PART 18
THIS EQUIPMENT COMPLIES WITH
GROUP 2 CLASS A ISM
F.C.C. REGUL ATIONS PART 18
Actuator Interface Connector
Serial Port (RS-232) Connector for Host Computer
See
Never operate the System with the RF Cable disconnected or if the RF
Cable is damaged.
for a dimensional drawing of the 2000X
Fans
Model Data Tag
Table 4.4 Input Power requirements
RF Connector
(ultrasonic energy out)
MODEL
EDP NO.
INPUT
MAX POWER
Serial No.
Year & Month of Manufacture
Power Cord
for plug and
1019571 REV. 03
Advertisement
Table of Contents
