Table of Contents
Advertisement
Figure 4.24 Installing a 40 kHz Stack in a Branson Actuator
Adapter Sleeve
Contact Terminal
Converter
Booster
Adapter Sleeve
Ring Nut
4.
Pull the door straight off and set it aside.
CAUTION
5. Take the assembled sleeve and align the ring nut on the booster just above the support washer
in the carriage. Firmly push the sleeve into place, with the acorn nut on the top of the converter
making contact with the contactor in the top of the carriage.
6. Reinstall the door assembly, and start the four door screws.
7. Align the horn by rotating it, if necessary. Torque the carriage door to 20 in.-lbs to secure the
stack.
NOTICE
74
Main Support
Assembly
Adapter
Sleeve
Carriage
Support Washer
Screw
Stack Assembly
Do not attempt to hold the sleeve in a vise. It can be easily crushed
or damaged.
Branson recommends using the CA-30 converter instead of the CJ-30
converter with the sleeve assembly.
Carriage Door
Adapter Sleeve
Contact Terminal
Carriage
Ring Nut
Cap Screw
T-Handle
Wrench
Ring Nut
Stack Assembly
(no Horn installed)
1019571 REV. 03
Advertisement
Table of Contents
