Table of Contents
Advertisement
4.8
Assemble the Acoustic Stack
CAUTION
CAUTION
Table 4.11 Tools
15, 20, and 30 kHz Torque Wrench Kit
40 kHz Torque Wrench
15 kHz spanner Wrench
20 kHz Spanner Wrench
30 kHz Spanner Wrench
40 kHz Spanner Wrench
Silicone Grease
4.8.1
For a 15 kHz System
Table 4.12 Acoustic Stack Assembly for a 15 kHz System
Step
1
2
68
The following procedure must be performed by a setup person. If
necessary, secure the largest portion of a square or rectangular horn
in a soft jawed (brass or aluminum) vise. NEVER attempt to assemble
or remove a horn by holding the converter housing or the booster
clamp ring in a vise.
Do not use silicone grease with Mylar washers. Use only 1 (one)
Mylar washer of the correct inside and outside diameters at each
interface.
Tool
Clean the mating surfaces of the converter, booster, and horn. Remove any
foreign material from the threaded holes.
Install the threaded stud into the top of the booster. Torque to 450 in-lbs,
50.84 Nm. If the stud is dry, apply 1 or 2 drops of a light lubricating oil
before installing.
EDP Number
101-063-787
101-063-618
201-118-034
101-118-039
201-118-033
201-118-024
101-053-002
Action
1019571 REV. 03
Advertisement
Table of Contents
