Address Setting For Wireless Remote Controller - Daikin VRV Aurora RXLQ-TATJU Series Service Manual

Address Setting for Wireless Remote Controller

4. Address Setting for Wireless Remote Controller
If setting multiple wireless remote controllers to operate in one room, perform address setting for
the receiver and the wireless remote controller.
(This includes an individual remote controller control using the group operation.)
(For the wiring for the group operation, please refer to the installation manual attached to the indoor
unit.)
Setting for signal receiver PCB
The address for the receiver is set to 1 at the factory. To change the setting, set the wireless
address switch (SS2) on the signal receiver PCB according to the table below.
Setting for wireless remote controller
The address for the wireless remote controller is set to 1 at the factory. To change the setting,
proceed as follows:
1. Press FILTER SIGN RESET button and INSPECTION/TEST button at the same time for 4
2. Press FAN button and select A or b. Each time the button is pressed, the display switches
3. Press UP button or DOWN button to select an address from 1-3 as same as the receiver.
4. Press RESERVE button to confirm the setting.
73
Unit No. No. 1
Wireless address
switch (SS2)
The side painted black indicates
the switch knob position.
Transmitter assembly
S
M
2 3
1
SS1
SS2
seconds to enter field setting mode. (SETTING is indicated on the display.)
between A and b.
Address can be set from 1-6, but the receiver does not work with addresses 4-6.
No. 2 No. 3
SiUS341802EC
Part 3 Remote Controller