Brc1H71W; Wireless Remote Controller - Daikin VRV Aurora RXLQ-TATJU Series Service Manual

SiUS341802EC
2.2

BRC1H71W

Home screen
Room
Information screen
2.3

Wireless Remote Controller

If the unit stops due to an error, the operation indicating LED on the signal receiving part of indoor
unit blinks. The error code can be determined by following the procedure described below. (The
error code is displayed when an operation error has occurred. In normal condition, the error code of
the last problem is displayed.)
1. Press INSPECTION/TEST button to enter inspection mode. Then the figure 0 blinks on the unit
2. Press UP button or DOWN button and change the unit number until the receiver of the remote
3. Press MODE button. The left 0 (upper digit) indication of the error code blinks.
4. Press UP button or DOWN button to change the error code upper digit until the receiver of the
Part 6 Service Diagnosis
When the indoor unit is in error, the controller will display
Auto Cool
on the home screen.
73
Press and hold
12:34
The unit number and error code will be displayed at the
bottom of the information screen.
A3 (Unit 00)
number display.
controller starts to beep.
3 short beeps: Follow all steps below.
1 short beep: Follow steps 3 and 4. Continue the operation in step 4 until you hear a
continuous beep. This continuous beep indicates that the error code is confirmed.
Continuous beep: There is no abnormality.
indoor unit starts to beep.
Error Code via Remote Controller
on the Home screen for 5 seconds.
UP button
DOWN button
Unit number
MODE button
INSPECTION/TEST button
214