Address Setting For Wireless Remote Controller - Daikin RXSQ24TAVJU Service Manual

Address Setting for Wireless Remote Controller

4. Address Setting for Wireless Remote Controller
If setting multiple wireless remote controllers to operate in one room, perform address setting for the receiver and
the wireless remote controller.
(This includes an individual remote controller control using the group operation.)
(For the wiring for the group operation, please refer to the installation manual attached to the indoor unit and
technical guide.)
Setting for signal receiver PCB
The address for the receiver is set to 1 at the factory. To change the setting, set the wireless address switch
(SS2) on the signal receiver PCB according to the table below.
Unit No.
Wireless address
switch (SS2)
The side painted black indicates
the switch knob position.
Transmitter assembly
S
M
2 3
1
SS2
31
No. 1 No. 2
SS1
No. 3
SiUS331708EA
Remote Controller