Optional Interface For Compact 2 Basic Drives; Drive Parameter Settings - Invertek Drives Optidrive E3 ODE-3 Series User Manual

6.4. Optional Interface for Compact 2 Basic Drives

6.4.1. Installation
The Ethernet/IP interface is mounted underneath the control pod.
 Remove the control pod as described in the Compact 2 installation guide.
 Locate the Ethernet/IP interface in the slot below the control pod.
 Refi t the control pod.
6.4.2. Layout

6.5. Drive Parameter Settings

6.5. Drive Parameter Settings
6.5.1. Overview 6.5.1. Overview
The following parameter settings are required in the drive. For further description of the drive parameters, refer to the drive user guide. The following parameter settings are required in the drive. For further description of the drive parameters, refer to the drive user guide.
Drive Type Drive Type
Parameter Parameter
Drive Address Drive Address
Modbus RTU Baud Rate Modbus RTU Baud Rate
Modbus RTU Data Format Modbus RTU Data Format
Communication Loss Reaction Communication Loss Reaction
Command Source Selection Command Source Selection
www.invertekdrives.com
MAC Address shown here
P1: Primary Ethernet Port P1: Primary Ethernet Port
P2: Secondary Ethernet Port P2: Secondary Ethernet Port
WARNING! Do not connect Ethernet cables to the WARNING! Do not connect Ethernet cables to the
RJ45 port on the control Pod! RJ45 port on the control Pod!
Optidrive E3 (ODE-3-...) Optidrive E3 (ODE-3-...)
P-36 Index 1 P-36 Index 1
P-36 Index 2 P-36 Index 2
N/A N/A
P-36 Index 3 P-36 Index 3
P-12 P-12
Setting Setting
1 1
1 15.2kbps 1 15.2kbps
N-1 N-1
As required As required
Select for Fieldbus Control if control of the drive operation is required Select for Fieldbus Control if control of the drive operation is required
Version 1.02 | Fieldbus Guide | 17
6