Snmp - Dahua DHI-NVR5208-4KS2 User Manual

Parameter
Enable
SMTP Server
Port
User Name
Password
Anonymity
Mail Receiver
Email Address
Sender
Title
Attachment
Authentication
Interval (Sec.)
Health Enable
Interval (Min.)
Test
Step 3 Click Apply to complete the settings.

4.12.7 SNMP

This function is for some series only.
You can connect the Device with some software such as MIB Builder and MG-SOFT MIB
Description
Enable the email function.
Enter the address of SMTP server of sender's email account.
Enter the port value of SMTP server. The default value setting is
25. You can enter the value according to your actual situation.
Enter the user name and password of sender's email account.
If enable the anonymity function, you can login as anonymity.
In the Mail Receiver list, select the number of receiver that you
want to receive the notification. The Device supports up to three
mail receivers.
Enter the email address of mail receiver(s).
Enter the sender's email address. It supports maximum three
senders separated by comma.
Enter the email subject.
Supports Chinese, English and Arabic numerals. It supports
maximum 64 characters.
Enable the attachment function. When there is an alarm event, the
system can attach snapshots as an attachment to the email.
Select the encryption type: NONE, SSL, or TLS.
For SMTP server, the default encryption type is TLS.
This is the interval that the system sends an email for the same
type of alarm event, which means, the system does not send an
email upon any alarm event.
This setting helps to avoid the large amount of emails caused by
frequent alarm events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Enable the health test function. The system can send a test email
to check the connection.
This is the interval that the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no
interval.
Click Test to test the email sending function. If the configuration is
correct, the receiver's email account will receive the email.
Before testing, click Apply to save the settings.
Table 4-57
Local Basic Operation 278