Table of Contents
Advertisement
Step 2 Configure parameters. See Table 4-20.
Parameter
Channel
PTZ Type
Protocol
Address
Baud rate
Data Bits
Stop Bits
Parity
Step 3 Click Apply.
4.4.2 PTZ Control
PTZ control panel performs the operations such as directing camera in eight directions,
Figure 4-83
Description
In the Channel list, select the channel that you want to connect the PTZ
camera to.
Local: Connect through RS-485 port.
Remote: Connect through network by adding IP address of PTZ
camera to the Device.
In the Protocol list, select the protocol for the PTZ camera such as
PELCOD.
In the Address box, enter the address for PTZ camera. The default is 1.
The entered address must be the same with the address configured on
the PTZ camera; otherwise the system cannot control PTZ camera.
In the Baud rate list, select the baud rate for the PTZ camera. The default
is 9600.
The default is 8.
The default is 1.
The default is NONE.
Table 4-20
Local Basic Operation 145
Advertisement
Table of Contents
