Local Basic Operation; Getting Started; Boot Up; Device Initialization - Dahua DHI-NVR5208-4KS2 User Manual

Slight difference may be found on the user interface. The following figures for reference only.

4.1 Getting Started

This chapter introduces device initial settings such as boot up, device initialization, reset
password, and quick settings.

4.1.1 Boot up


For device security, connect the NVR to the power adapter first and then connect the device
to the power socket.

The rated input voltage matches the device power button. Make sure the power wire
connection is OK. Then click the power button.

Always use the stable current, if necessary UPS is a best alternative measure.
Step 1 Connect the device to the monitor and then connect a mouse.
Step 2 Connect power cable.
Step 3 Click the power button at the front or rear panel and then boot up the device. After
device booted up, the system is in multiple-channel display mode by default.

4.1.2 Device Initialization

If it is your first time to use the device, set a login password of admin (system default user). You
can select to use unlock pattern to login or not at your own choosing.
For your device safety, keep your login password of admin well after the initialization steps, and
change the password regularly.
Step 1 Boot up NVR.
The Device Initialization interface is displayed. See Figure 4-1.

4 Local Basic Operation

Local Basic Operation 71