Dahua DHI-NVR5208-4KS2 User Manual page 226

Step 2 Select the Enable check box to enable ANPR.
Step 3 Click Regular (default), Blacklist or Whitelist tab to configure it.
Before activate blacklist alarm or whitelist alarm, you need to add the corresponding
plate information. Refer to "4.7.3.2 B/W List" for detailed information.

Regular: Device triggers an alarm when it detects any plate number.

Blacklist: Device triggers an alarm when it detects plate number in the blacklist.

Whitelist: Device triggers an alarm when it detects plate number in the whitelist.
Step 4 Set parameters. See Table 4-42.
Parameter Description
Configure the period and in the set time range, the corresponding configuration
Period
item will be linked to start the alarm.
The alarm device (such as lights, sirens, etc.) is connected to the alarm output
Alarm Out port. When an alarm occurs, the NVR device transmits the alarm information to
the alarm device.
When the alarm ends, the alarm extended for a period of time. The time range is
Latch
from 0 seconds to 300 seconds.
Select the check box. When an alarm occurs, the NVR device uploads an alarm
signal to the network (including the alarm center).
Alarm
Upload  This function is for some series products only.
You need to set the alarm center first. For details, see "4.12.9 Alarm

Centre."
Select the check box. When an alarm occurs, the NVR device sends an email to
the set mailbox to notify the user.
Send Email
You need to set the email first. For details, see "4.12.6 Email."
Select the check box and select the needed recording channel (support multiple
choices). When an alarm occurs, the NVR device activates the channel for
recording.
Record
Channel
You need to enable intelligent recording and auto recording first. For details, see
"4.1.4.6 Schedule."
Select the check box and click Setting to select the channel and PTZ action.
When an alarm occurs, the NVR device associates the channel to perform the
corresponding PTZ action. For example, activate the PTZ in channel one to turn
to the preset point X.
PTZ
Activation
 Tripwire alarm supports to activate PTZ preset point only.
You need to set the corresponding PTZ actions first, see "4.4.3 Configuring

PTZ Functions."
Table 4-42
Local Basic Operation 215