Nvr48/48-16P Series - Dahua DHI-NVR5208-4KS2 User Manual

Name
CTRL 12V
+12V
RS-232
VGA
PoE PORTS

2.2.11 NVR48/48-16P Series

The NVR48 series rear panel is shown as below. See Figure 2-50.
The NVR48-16P series rear panel is shown as below. See Figure 2-51.
Name
Power switch
/
/
RS232 debug
COM.
VGA video output
port
/
Figure 2-50
Figure 2-51
Table 2-23
/
Function
Controller 12V power output. It is to control the on-off
alarm relay output. It can be used to control the
device alarm output. At the same time, it can also be
used as the power input source of some devices such
as the alarm detector.
+12V power output port. It can provide the power to
some peripheral devices such as the camera or the
alarm device. Please note the supplying power shall
be below 1A.
It is for general COM debug to configure IP address
or transfer transparent COM data.
VGA video output port. Output analog video signal. It
can connect to the monitor to view analog video.
Bult-in Switch. Support PoE or ePoE function.

For ePoE series product, port 1 to port 8 are the
ePoE ports.
meters@100Mbps, 800 meters@10Mbps. Port 9
to port 16 are general PoE ports.

The 16 PoE series product supports total 150W.
Function
Power on-off button
ePoE port supports
Front Panel and Rear Panel 34
300