Dahua DHI-NVR5208-4KS2 User Manual page 108

Parameter
RTSP Port
HTTP Port
User Name
Password
Remote Channel
Decoder Buffer
Protocol Type
Encrypt
3)
The remote device information is displayed on the Added Device list.
Step 4 Click Next to complete the remote device registration.
Click to change the remote device information. Click
Once the multiple-sensor device has registered to the device system displays the channel status on
the Link info. See Figure 4-30. It shows one remote device has occupied two channels: D1, D3.
Description
The default is 192.168.0.0 which the system cannot connect to.
The default value setting is 554. You can enter the value according to
your actual situation.
The default value setting is 80. You can enter the value according to
your actual situation.
If you enter other value, for example, 70, and then you should enter
70 after the IP address when logging in the Device by browser.
Enter the user name of the remote device.
Enter the password of the user for the remote device.
Enter the remote channel number of the remote device that you want
to add.
In the Decoder Buffer list, select Default, Realtime, or Fluent.
 If the remote device is added through private protocol, the default
type is TCP.
If the remote device is added through Onvif protocol, the system

supports Auto, TCP, UDP, or MULTICAST.
If the remote device is added through other manufacturers, the

system supports TCP and UDP.
If the remote device is added through Onvif protocol, selecting the
Encrypt check box will provide encryption protection to the data being
transmitted.
To use this function, the HTTPS function should be enabled for the
remote IP camera.
Click OK.
to delete remote device.
Local Basic Operation 97