Table of Contents
Advertisement
You can always use the reset button on the mainboard to reset the Device to the factory default
settings.
Reset button is for some series products only.
Step 1 Disconnect the Device from power source, and then remove the cover panel. For details
about removing the cover panel, see "3.4 HDD Installation."
Step 2 Find the reset button on the mainboard, and then connect the Device to the power
source again.
Step 3 Press and hold the reset button for 5 seconds to 10 seconds. See Figure 4-14 for the
location of the reset button.
Step 4 Reboot the Device.
After the Device is rebooted, the settings have been restored to the factory default. You
can start resetting the password.
4.1.4 Quick Settings
After you successfully initialized the device, it goes to startup wizard. Here you can quickly
configure your device. Click Next, device goes to General interface.
The startup wizard interface only displays after you first login the device and have set the admin
password. See Figure 4-15.
Figure 4-14
Local Basic Operation 81
Advertisement
Table of Contents
