Mitsubishi Electric MELSEC-QD75MH1 User Manual page 726

15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
74 224 374 524
75 225 375 525
76 226 376 526
77 227 377 527
78 228 378 528
79 229 379 529
80 230 380 530
81 231 381 531
82 232 382 532
83 233 383 533
Set range
(Setting with PLC program)
<OPR speed>
1 to 50000000 [PLS/s]
1 to 2000000000 [mm/min or others]
<Creep speed>
1 to 50000000 [PLS/s]
1 to 2000000000 [mm/min or others]
0, 1
0 to 65535
0 to 2147483647
0, 1, 2, 3
0, 1, 2, 3
• Set the value inside the setting range.
• Set the speed to the bias speed at start or higher.
(Refer to Section 5.2.5)
• Set the value inside the setting range.
• Set the speed to that below the home position return
(OPR) speed.
• Set the value to the bias speed at start or higher.
(Refer to Section 5.2.5)
After setting the value inside the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
15 - 33
MELSEC-Q
Remedy