S S P P E E C C I I A A L L P P R R O O C C E E D D U U R R E E S - BRP can-am OUTLANDER 2024 Operator's Manual

S S P P E E C C I I A A L L P P R R O O C C E E D D U U R R E E S S
F F u u e e l l F F l l o o o o d d e e d d E E n n g g i i n n e e
If the engine does not start and it is fuel-flooded, this special mode can
be activated to prevent fuel injection and to cut ignition while cranking.
Proceed as follows:
1. Move shift lever in park position.
2. Install key on D.E.S.S. post or turn the ignition key in ON position.
3. Press completely and HOLD throttle lever.
4. Press the engine START button for 10 seconds.
5. Release throttle lever.
6. Press the START button again to allow starting.
If the engine does not start:
1. Unplug injector electrical connector
2. Clean the spark plug caps area then remove them.
3. Remove the spark plugs.
4. Crank engine several times.
5. Install new spark plugs if possible or clean and dry spark plugs.
6. Start engine as explained above.
If engine continues to flood, see an authorized Can-Am Off-road
dealer.
N N O O T T I I C C E E
V V e e r r i i f f y y t t h h a a t t t t h h e e r r e e i i s s n n o o f f u u e e l l i i n n e e n n g g i i n n e e o o i i l l . . I I f f s s o o , , r r e e p p l l a a c c e e e e n n g g i i n n e e o o i i l l . .
W W a a t t e e r r I I n n t t o o t t h h e e C C V V T T
The CVT drain plug is located on the rear portion of the CVT cover.
Remove the LH side panel to access it.
198