P P u u l l l l e e r r / / l l o o c c k k i i n n g g t t o o o o l l
( ( P P / / N N 5 5 2 2 9 9 0 0 3 3 6 6 0 0 9 9 8 8 ) )
3. Tighten to open the pulley.
4. To remove belt, slip the belt over the top edge of fixed sheave.
I I n n s s p p e e c c t t i i n n g g t t h h e e D D r r i i v v e e B B e e l l t t
1. Inspect drive belt for cracks, fraying or abnormal wear. Replace if
necessary.
2. Check drive belt width at cord level. Replace if the belt is out of the
specification.
Service limit
MAINTENANCE PROCEDURES
Drive Belt Width
30 mm
(1.181 in)
289